PIAGGIO MP3 500 Manuel utilisateur

PDF
Document
Manuel MP3 500 ie SPORT Business LT (2011) + AI Chat | Fixfr
/

User questions

C C

James C.

What does the engine management and injection fault indicator light mean on the device?

No votes

The viewed document refers to an engine management and injection fault indicator light (L). It is important to check this light in case of an incident. If the light comes on during braking, idling, or cornering, it is necessary to check the level and inspect the lubrication circuit. Additionally, several immobilizer-related diagnostic codes can be viewed via LED flashes, indicating various issues ranging from a missing transponder signal to key recognition anomalies.

O G

Robert O.

How to check the engine oil level?

No votes

With the engine cold, place the vehicle on the center stand on flat ground. Unscrew and wipe the dipstick, then reinsert it by screwing it in completely. Remove it again to verify that the level is between the minimum and maximum marks. If adding oil is necessary, do not exceed the maximum level and use the recommended oil type (AGIP CITY HI TEC 4T). If the vehicle was recently used, wait at least 10 minutes after stopping the engine before checking.

O G

Robert O.

How to check and top up the engine oil level?

No votes

With the engine cold and the vehicle on a level surface via the center stand, unscrew and wipe the dipstick. Reinsert it fully, then remove it to ensure the level is between the minimum and maximum marks. If necessary, add the recommended oil (AGIP CITY HI TEC 4T) without exceeding the maximum mark. If the vehicle was recently used, wait 10 minutes before checking.

V H

Jennifer V.

What are the specifications for the indicator light bulbs and their corresponding fuses?

No votes

The indicator lights use 12 V - 10 W incandescent bulbs (type BAU 15S). The system is protected by a 15 A fuse for the control device and a 7.5 A fuse for the power supply.

V H

Jennifer V.

What are the specifications for the turn signal bulbs and the corresponding fuses?

No votes

The turn signals use incandescent bulbs type BAU 15S, with a power rating of 12 V - 10 W. The electrical system is protected by Fuse No. 3 (15 A) for the control device and Fuse No. 12 (7.5 A) for the power supply.

V H

Jennifer V.

What are the specifications for replacing the turn signal bulbs?

No votes

The turn signals use 12V - 10W incandescent bulbs (type BAU 15S). There are four bulbs in total: two for the front and two for the rear. In case of malfunction, check fuse n°3 (15 A) for the control device and fuse n°12 (7.5 A) for the power supply.

V H

Jennifer V.

How to replace the turn signal bulbs and which fuses protect them?

No votes

Use incandescent bulbs of type BAU 15S (12V - 10W). Fuse n°3 (15 A) protects the turn signal control device, and fuse n°12 (7.5 A) protects the power supply for the control device.

Preparing document for printing…
0%