Electrolux EDP2074PDW Manuel du propriétaire

PDF
Document
Electrolux EDP2074PDW Notice d'utilisation + AI Chat | Fixfr
/

User questions

D P

Mary D.

What to do if the dryer stops shortly after starting despite a long timer duration?

No votes

Ensure the condensation tank is empty and the filters/condenser are clean. If the drum sensors are dirty, clean them with a damp cloth. For very small loads, use a manual timer program instead of automatic cycles to prevent the sensors from stopping the device prematurely.

D P

Mary D.

Why does the dryer stop after a very short period of operation when the timer shows a longer duration?

No votes

A premature stop may be caused by a full condensation water tank, a dirty drum or conductivity sensor, or an insufficient load size. Ensure the water tank is empty and the drum is clean. For small loads that the sensors may not detect, use the manual 'Timer' program instead of automated cycles.

D P

Mary D.

Why does the dryer stop after 1 minute 40 when the timer indicates 140?

No votes

If the dryer stops prematurely, several causes are possible:

  1. The condensation water tank is full. It must be emptied and the appliance restarted.
  2. The conductivity sensor or the drum is dirty, making the appliance incorrectly detect that the laundry is already dry. Clean the drum and check humidity settings.
  3. The load is insufficient or too dry. Use a Timer program for small quantities.
  4. The lint filter or condenser is clogged. Check their cleanliness.
  5. An error code appears. Turn the appliance off and on again to reset it.
D P

Mary D.

What should be checked if the tumble dryer timer indicates a long duration but the device stops after a short time?

No votes

If the tumble dryer stops prematurely despite a longer duration shown on the timer, check the following: 1. Ensure the condensation water tank is empty, then press Start/Pause. 2. Clean the inside of the drum with a damp cloth and mild soap, and refer to the humidity sensor settings. 3. For small or very dry loads, use the 'Timer' program. 4. Verify that the lint filter and condenser are perfectly clean. 5. If an error code (e.g., E51) or 'Err' appears, reset the device by turning it off and on again.

D P

Mary D.

Why does the dryer stop after 1 minute and 40 seconds when the timer indicates 140?

No votes

This issue may be caused by a full condensation tank, a dirty conductivity sensor or drum, or a laundry load that is too small. For small loads, it is recommended to use the 'Timer' program. Ensure that the filters and condenser are clean and that no error codes are displayed.

D P

Mary D.

Why does the dryer stop after a very short time despite the timer showing a longer duration?

No votes

The device may stop prematurely if the condensation tank is full, or if the moisture sensors/drum are dirty, causing an incorrect 'dry' reading. Ensure the filters and condenser are clean. For very small loads that sensors might not detect, use the 'Timer' program instead of automatic cycles.

D P

Mary D.

What should be checked if the dryer timer shows 140 (1h 40m) but stops after 1 minute 40 seconds?

No votes

If the dryer timer shows 140 (1h 40m) and stops after only 1 minute 40 seconds, check the following: the condensation water tank might be full (empty it and press Start/Pause); the conductivity sensor or drum might be dirty (clean the drum's interior); the laundry load might be insufficient or too dry (use the 'Timer' program for small quantities); the lint filter or condenser might be obstructed; or an error code (e.g., E51, Err) might be displayed, which can sometimes be resolved by turning the appliance off and on again.

Preparing document for printing…
0%