Danfoss ETS 12.5 12½. 25 & KVS 15 Guide d'installation
PDF
Documento
034R9797 034R9797 Instruction ETS 12½, ETS 25 & KVS 15 Tilladt omgivelsestemperatur Allowable ambient temperature Zulässige Umgebungstemperatur Température ambiante admissible Temperatura ambiente permisible Anvendelse Application Anwendung Application Aplicación ETS 12½, 25 and KVS 15 PS/MWP = 45.5 (659.9 psig) Montage Mounting Einbau Montage Installación Lodning Brazing Löten Soudure Soldadura © Danfoss A/S 11-2010 (AC-SMC/bpv) Samling Assembling Zusammenbau Assemblage Montaje DKRCC.PI.VD1.C2.53 / 520H4707 Adskillelse Disassembling Zerlegung Désassemblage Desmontaje Tilslutning Connection Anschluss Raccordement Conexión Parameter Stepper motor type Step mode Phase resistance Phase inductance Holding current ETS 12½, 25 & KVS 15 Bi-polar - permanent magnet 2 phase full step 52Ω ±10% 85 mH Depends on application. Full current allowed (100% duty cycle) Step angle 7.5° (motor), 0.9° (lead screw), Gearing ration 8.5:1. (38/13)2:1 Nominal voltage (Constant voltage drive) 12 V dc -4% +15%, 150 steps/sec. Phase current (Using chopper drive) 100 mA RMS -4% +15%, Max. total power Voltage / current drive: 5.5 / 1.3 W (UL: NEC class 2) Step rate 150 steps/sec. (constant voltage drive) 0-300 steps/sec. 300 recommended (chopper current drive) Total steps ETS 25, 12": 2625 [+160 / -0] steps Full travel time 17 / 8.5 sec. (voltage / current) Reference position Overdriving against the full close position Electrical connection M12 connector • • • • Advarsel! Warning! Achtung! Attention ! Advertencia 2 Ventilen må kun tilsluttes regulator. Do not apply power directly to valve. Das Ventil darf nicht direkt angeschlossen werden. Ne pas raccorder l'alimentation électrique directement sur la vanne. • No aplicar tensión directamente a la válvula Motor and connection check • Tilslut aldrig spænding til en usamlet ventil. • Do not apply power to unassembled valve. • Das Ventil darf nur wenn komplett zusammengebau angeschlossen werden. • Ne pas raccorder l'alimentation électrique sur une vanne non assemblée. • No aplicar tensión a la válvula desmontada. DKRCC.PI.VD1.C2.53 / 520H4707 © Danfoss A/S 11-2010 (AC-SMC/bpv) ">
/
Scarica
Solo un promemoria. Puoi visualizzare il documento qui. Ma soprattutto, la nostra IA l''ha già letto. Può spiegare cose complesse in termini semplici, rispondere alle tue domande in qualsiasi lingua e aiutarti a navigare rapidamente anche nei documenti più lunghi o complicati.