▼
Scroll to page 2
of
3
A25-M info@psiaudio.com SWISS MADE BY RELEC SA 1400 YVERDON www.psiaudio.com Technical data sheet PSI AUDIO A23-M PSI A23-M s1 / typical characteristics subject to change without prior notice / © RELEC SA. A23-M info@psiaudio.com www.psiaudio.com SWISS MADE BY RELEC SA 1400 YVERDON All measurements in anechoic room acoustical axis at 1 meter POWER PSI Audio Hand Made Neodymium Tweeter AOI* CPR* HP PSI Audio Hand Made Neodymium mid POWER G AOI* HP *C P R : Compensated Phase Response system. *A O I : Adaptive Output Impedance system. *PSC : Phantom Standby Control. POWER G LEVEL INPUT 1=Gnd 2=Hot 3=Cold ROLL OFF HP LP LIMITER AOI* LP PSC* TEMP. SENS Hi. ± 57V 115/220V Flow Guide Low ± 18V POWER LIMIT MAINS EMI LP ON/OFF [dB] FUSE TRANSF. RECT. STANDBY REG. SPL@-10dBu/1m A23-M -10dB Roll Off +10 140+70+50 W 260 W Sym, 10k Ohms 0.775 V 8 dBA 0 -10 -20 -30 20 50 1k 500 200 100 [dB] 2k 5k 10k 20k [Hz] 2k 5k 10k 20k [Hz] 2k 5k 10k 20k [Hz] THD@-10dBu/1m A23-M -20 24 Vpp / 20.7 dBu -30 109 dB -40 120 dB / peak 123 dB -50 34 - 23000 Hz -60 20 ±1.5 dB (39Hz - 20kHz) < 1% (100Hz-20kHz) 50 1k 500 200 100 [Deg] ACOUSTIC PHASE A23-M +540 ±45° (220Hz - 20kHz) +450 +360 90° x 80° (H x V) +270 +180 3 Way(s) +90 620Hz, 3.2kHz -90 0 -180 20 50 1k 500 200 100 Ø 210 mm / Ø 170 mm Ø 120 mm / Ø 56 mm [dB] Ø 100 mm / Ø 25 mm 120 1 x XLR F / 3P 110 1=GND, 2=(+), 3=(-) MDF Max Continuous SPL 1m A23-M 130 100 8k 10k 12k5 16k 10k 12k5 16k 6k3 6k3 8k 4k 5k 5k 3k15 3k15 4k 2k 2k5 2k5 1k6 5 2 PSI A23-M s1 / typical characteristics subject to change without prior notice / © RELEC SA. 1k25 1k 800 630 500 400 315 250 200 160 125 100 80 63 50 1 40 Humidité moy / max < 75% / < 90% Mean / Max Humidity Température externe 5 - 40 °C External Temperature Directivity Factor A23-M 10 31 Tension de secteur 115/230V±10%(50-60Hz) Voltage Consommation 1.8 - 8 - 200 W Consumption Standby-Idle-Max 2k [Q] 18.0 / 20.2 Kg 1k6 1k 280 x 500 x 340 1k25 800 630 500 315 400 250 200 125 160 100 63 80 50 31 40 25 90 25 Puissance RMS RMS Power Puissance programme Program Power Impédance d'entrée Input Impedance Sensibilité pour 100 dB @ 1m Sensitivity for 100 dB @ 1m Bruit propre, 1m, champ libre Self-Generated Noise, 1m, Free Space Saturation d'entrée Input Overload Niveau max. continu (single), 1m Continuous Max SPL (single), 1m Niveau max. programme (pair), 1m Program Max SPL (pair), 1m Réponse à -6 dB Response at -6dB Tolérances Tolerances Distorsions THD Distortion THD Tolérances de phase Phase Tolerances Dispersion (B.R. 4 - 16 kHz) à -6 dB Dispersion (P.N. 4 - 16 kHz) at -6 dB Système System Fréquence de coupure Crossover Frequency Dim. basse ext. / membrane Woofer's Dim. Ext. / Diaphragm Dim. medium ext. / membrane Medium's Dim. Ext. / Diaphragm Dim. aigue ext. / membrane Tweeter's Dim. Ext. / Diaphragm Connecteurs Connectors Entrée du signal Signal Input Matériaux du boîtier Box Material Dimensions du boîtier L x H x P mm Cabinet Dimensions W x H x D mm Poids brut / net Gross / Net Weight A23-M info@psiaudio.com www.psiaudio.com SWISS MADE BY RELEC SA 1400 YVERDON All dimensions are in mm Mounting 230 Gravity center 500 Front Minimum well-aired space 160 Front 280 70 Bottom view 340 Side view Refer to user manual for information about installation and safety instructions Acoustical axis 140 150 390 380 Front view Mid/High baffle orientation As mentioned on the drawing here above, you can change the orientation of the mid/high baffle. Before this change, the power cable must not be connected. Be sure that this operation does not cause any short-circuit to the connections of the baffle. Measurement environment: Large anechoical room Temperature 23±2°C Humidity 50±20% PSI A23-M s1 / typical characteristics subject to change without prior notice / © RELEC SA.